HEIDENHAIN iTNC 530 HSCI - Commissioning an Analog Axis

1060 HEIDENHAIN Technical Manual iTNC 530 HSCI
6.14.7 Commissioning an analog axis
Temporary
input values
 Enter the following temporary input values when you begin
MP Temporary
input value
Meaning
MP1030.x 0.01 Positioning window
MP1090.x 1 Maximum permissible jerk on the tool path
MP1092 <Maximum rapid
traverse>
Feed rate threshold from which MP1090.1
becomes effective
MP1110.x 2.0 Standstill monitoring
MP1140.x 10 Movement monitoring
MP1410.x 0.5 Position monitoring in operation with
velocity feedforward control (erasable)
MP1420.x 2 Position monitoring in operation with
velocity feedforward control
(emergency stop)
MP1510.x 1 k
v
factor for velocity feedforward control
MP1710.x 50 Position monitoring in operation with
following error (erasable)
MP1720.x 50 Position monitoring in operation with
following error (EMERGENCY STOP)
MP1810.x 1 k
v
factor for control with following error
MP1820.x 1 Multiplier for the k
v
factor
MP1830.x 100 Characteristic curve kink point