July 2013 7.7 Special functions 1097
Error code:
Marker Value Meaning
M4203 0 No error
1 Axis does not exist or status interrogation faulty
W1022 1 Invalid value for Mode parameter, CC code
2 Invalid axis number programmed
3 Invalid value for Channel parameter programmed
4 Memory range for the programmed double-word
address is too small or does not exist
5 Programmed address is not a double-word address
(not divisible by 4)
6 Programmed data channel is already being used
20 Call was not in a submit/spawn job
45 Internal error
51 Programmed CC data is not available for this axis on
the CC, or the PLC module is not supported by this NC
software
61 Internal error
To Next Page
Loading...
