July 2013 8.1 Display and operation 1163
7 Selected axis for actual position
capture in Programming and Editing
mode
0 to 17: Axis 1 to 18
8 Selected axis for actual position
capture in Positioning with MDI
mode
0 to 17: Axis 1 to 18
9 Handwheel axis –1: None or more than one
0 to 2: X, Y, Z
3 to 17: Axis 4 to 18
10 Handwheel axis, bit-encoded Bit 0: X axis
Bit 1: Y axis
Bit 2: Z axis
Bit 3 to bit 17: Axis 4 to 18
Handwheel subdivision factor
11
12
13
14
15
X key
Y key
Z key
IV key
V key
0 to 10
16 Input format of the $MDI file 0: *.H (conversational NC PGM)
1: *.I file (ISO NC PGM)
17 Display format 0: mm
1: inches
18 Tilting the working plane Bit 0=1: Tilting is active (manual and/or during program
run)
Bit 1=1: Tilting is active in manual operation
Bit 2=1: Tilting is active in program run
19 Active line in the *.CMA file >=0: Line number
–1: No *.CMA file
20 HR 410 speed 0: Slow
1: Medium
2: Fast
21 Control model 0: TNC 310
1: TNC 370
2: TNC 410
3: TNC 426 CA/PA
4: TNC 426 CB/PB/M or TNC 430 CA/PA/M
5: iTNC 530
6: iTNC 530 (with Windows 2000/XP)
20: ATEK M
22 Status of M128 0: M128 not active
1: M128 active
23 Handwheel superimposition with
M118
0: M118 not active
Bit 0 to 17: Axis 1 to 18
26 Jog increment
27 Traverse range
28 Query of the superimposed operating
mode "Table editing" in the "Machine"
operating mode
0: No table in editing mode
3: Tool table in editing mode
4: Pocket table in editing mode
Transferred number Return code
To Next Page
Loading...
