1164 HEIDENHAIN Technical Manual iTNC 530 HSCI
Call:
PS B/W/D/K <Number of the desired status information>
CM 9035
PL B/W/D <Status information>
Error code:
Handwheel subdivision factor
31
32
33
34
35
36
37
38
39
Axis 1
Axis 2
Axis 3
Axis 4
Axis 5
Axis 6
Axis 7
Axis 8
Axis 9
0 to 10
Tool change
50
51
52
53
54
Tool change sequence (see FN18:
SYSREAD ID61 NR0)
Pocket number for reserve
Magazine number for reserve
Pocket number for insertion
Magazine number for insertion
Handwheel
70
71
Active handwheel
Standard handwheel
100 Number of the tool axis
1000 Table editor (only in a spawn job or
submit job)
>= 0: Active line in the table editor
–1: Table editor not active
1001 Pallet table (only in a spawn job or
submit job)
>= 0: Active line in the pallet table
–1: Pallet table not active
1002 Status of pallet machining –1: Main program is not a pallet table
0: Machining was not started
1: NC program is selected but not started
2: NC program was started
3: Pallet-change macro was started
4: Macro from the PALEPILOG entry in NCMAKRO.SYS
was started
5: Pallet-change macro was started by the PLC
(Module 9280)
Transferred number Return code
Marker Value Meaning
M4203 0 No error
1 Error code in W1022
W1022 1 Status information invalid
20 Call was not in a submit or spawn job
To Next Page
Loading...
