HEIDENHAIN iTNC 530 HSCI - Editor Operating Modes; Machine Operating Modes

1166 HEIDENHAIN Technical Manual iTNC 530 HSCI
"Machine"
operating modes
 "Machine" main operating modes
• Traverse reference points (not with absolute encoders)
• Manual Operation
• El. Handwheel
• Positioning with Manual Data Input
Machine individual NC blocks without a special program context
• Program Run, Single Block
Machine an NC program block by block. Each NC block must be started
manually.
• Program Run, Full Sequence
Completely machine the NC program
 "Machine" background operating modes (cannot be called from every main
operating mode)
• MOD
Basic settings and information
• Program Management/Interfaces
File manager and configuration of external interfaces
• Edit Tool Table
• Edit Pocket Table
• Edit Other Tables
"Editor"
operating modes
 "Editor" main operating modes
• Programming and Editing
• Test Run
Virtual machining of a workpiece with nearly real-time graphic
simulation
 "Editor" background operating modes
• MOD
General settings and settings via code number
• Program Management/Interfaces
• MP Editor
• PLC programming
W272 Operating mode word
 If smarT.NC inactive --> M4163 = 0
1: MANUAL OPERATION
2: ELECTRONIC HANDWHEEL
3: POSITIONING WITH MANUAL DATA
INPUT
4: PROGRAM RUN, SINGLE BLOCK
5: PROGRAM RUN, FULL SEQUENCE
7: TRAVERSING THE REFERENCE
POINTS
 If smarT.NC active --> M4163 = 1
3: RUN ACTIVE UNIT
4: RUN SINGLE UNITS
5: RUN ALL UNITS
NC NC
Set Reset