HEIDENHAIN iTNC 530 HSCI - PLC Pop-Up Window

1192 HEIDENHAIN Technical Manual iTNC 530 HSCI
8.1.7 PLC pop-up window
The PLC pop-up (i.e. superimposed) window is shown in the following
operating modes:
 Manual Operation
 Positioning with Manual Data Input
 Program Run, Single Block
 Program Run, Full Sequence
 Activate a pop-up window with Modules 9215 or 9217
If you transfer file names without paths, the iTNC looks for the file in the
language-specific directory PLC:\LANGUAGE\<language>:
 With MP7230.3, select the active language (file).
When the PLC pop-up window is called, other pop-up windows (such as the
help window) are moved to the background and become active again after the
PLC pop-up window has been closed. The PLC pop-up window can be
displaced to the background by another pop-up window.
The modules do not return until the pop-up window is closed. They must be
called in a spawn job, not in a submit job, because otherwise the subsequent
submit jobs will not be run until the pop-up window is closed.
A pop-up window called with Module 9215 or 9217 can be ended with Module
9261.