HEIDENHAIN iTNC 530 HSCI - Status Information about the End of an NC Program

July 2013 8.1 Display and operation 1213
Status information
about the end of an
NC program
Module 9320 Status of the NC program end
Module 9320 can ascertain status information on the termination of the NC
program.
Call:
CM 9320
PL B/W/D <Cause of NC program end>
1: Emergency stop
2: Positioning error
3: Programmed stop (stop, M00)
4: Normal end
5: Geometry error
6: END PGM, M02
7: Internal stop
8: RS-232-C transmission error
PL B/W/D <Error class>
Bit 0: Reserved
Bit 1: Control loop
Bit 2: Probing
Bit 3: Limit switch
Bit 4: Error from FN14
Bit 5: Tool management
Bit 6: Programming error
Bit 7: Program selection/preparation
Bit 8: Pallet administration
Bit 9: Emergency stop
PL B/W/D <Help number>
–1: No help number
PL B/W/D <Block number in the NC program>
PL B/W/D <Additional information>
In the "tool management" error class:
Tool number
Set Reset
M4185 Internal stop performed NC PLC