July 2013 8.1 Display and operation 1253
M124 Ignore points for calculating the rounding arc with M112 A
M125
M126 Shortest-path traverse of rotary axes A
M127 Reset M126 E
M128 Retain position of tool tip when positioning tilting axes (TCPM) A
M129 Reset M128 E
M130 Within the positioning block: Points are referenced to the non-tilted
coordinate system
A
M131 A
M132 A
M133 E
M134 Exact stop at nontangential contour transitions when positioning with
rotary axes
A
M135 Reset M134 E
M136 Feed rate F in mm per spindle revolution A
M137 Reset M136 E
M138 Selection of tilted axes A
M139 A
M140 Retraction from the contour in the positive tool axis direction A
M141 Suppress touch probe monitoring A
M142 Delete modal program information A
M143 Delete basic rotation A
M144 Compensating the machine’s kinematics configuration for ACTUAL/
NOMINAL positions at end of block
A
M145 Reset M144 E
M146 Save the current geometry information in a temporary file (tool-
oriented pallet machining)
A
M147 A
M148 Retract the tool automatically from the contour at NC stop A
M149 Reset M148 E
M150 Utilize the traverse range completely in NC blocks A
M151 - M199
M200 Laser cutting: Direct output of the programmed voltage A
M201 Laser cutting: Output of voltage as a function of distance A
M202 Laser cutting: Output of voltage as a function of speed A
M203 Laser cutting: Output of voltage as a function of time (ramp) A
M204 Laser cutting: Output of voltage as a function of time (pulse) A
M205 - M299 A
M300 - M999
a. depends on MP7300
b. depends on MP7440
M function Meaning Effect
To Next Page
Loading...
