July 2013 8.1 Display and operation 1291
Entry Description
INFO MAIN PGM Started NC program or NC macro
INFO MAIN LINE Line number of the running NC program or NC macro
INFO MAIN PGMEND Information about the program end in program run
Byte 0/1 00 01 Emergency stop
00 02 Positioning error
00 03 Programmed stop
00 04 Block end in single block
mode
00 05 Geometry error
00 06 END PGM, M02
00 07 TNC STOP button
00 08 Data transmission error
(RS-422/RS-232)
Byte 2/3 xx xx Internal error class
Bytes 4 ... 7 xx xx xx xx Internal error code
Bytes 8 ... 11 xx xx xx xx Line number
Byte 12 ... 15 xx xx xx xx Reserved
In addition, when a program is stopped by an error
message, the following information is entered in the
log: NC program, line number, actual position, datum,
datum shifts, tool number
INFO MAIN MACEND Information about the end of an NC macro
Byte 0/1 00 01 Emergency stop
00 02 Positioning error
00 03 Programmed stop
00 04 Block end in single block
mode
00 05 Geometry error
00 06 END PGM, M02
00 07 TNC STOP button
00 08 Data transmission error
(RS-422/RS-232)
Byte 2/3 xx xx Internal error class
Byte 4...7 xx xx xx xx Internal error code
To Next Page
Loading...
