HEIDENHAIN iTNC 530 HSCI - Page 1292

1292 HEIDENHAIN Technical Manual iTNC 530 HSCI
INFO MAIN PATH PLCEDIT File for PLC editor
NCEDIT File for NC Editor
RUNPGM Main program for program run
RUNPALET Pallet table for program run
RUNDATUM Datum table for program run
RUNTOOL Tool table for program run
RUNTCH Pocket table for program run
SIMPGM Main program for program test
SIMDATUM Datum table for program test
SIMTOOL Tool table for program test
RUNBRKPGM Stopping point for block scan
SIMBRKPGM Stopping point for program test
RUNPRINT Path for FN15: PRINT for program run
SIMPRINT Path for FN15: PRINT for program test
MDIPGM File for positioning with manual data input
NCFMASK Mask for file management in the NC area
PLCFMASK Mask for file management in the PLC area
EASYDIR Paths for standard file management
TCHPATH Datum table for manual measurement
SIMTAB Freely definable table in program test
RUNTAB Freely definable table in program run
KINTAB Active kinematics table
INFO MAIN NCEVENT Entries via FN38: SEND from the Program Run, Full
Sequence or Program Run, Single Block operating
modes
MAIN NCTEVENT Entries via FN38: SEND from the Test Run operating
modes
INFO MAIN BUTTON
MOUSE "x" "y" "z" "a" "b"
Recording of mouse movements/buttons
 "x": P = Press, R = Release
 "y": L = Left button, R = Right button
 "z": Key pressed simultaneously
N = None, S = SHIFT, C = CTRL, A = ALT,
W = Windows, L = Left button, M = Middle button,
R = Right button
 "a": Position of the mouse pointer in X
 "b": Position of the mouse pointer in Y
INFO
WARNING
ERROR
PLC <log identifier> Entries through PLC modules 9275 and 9276
INFO SYS SHUTDOWN Control was shut down
REBOOT-TNC Control was rebooted (automatically)
REBOOT-
BIOS
Control was rebooted (automatically)
Entry Description