HEIDENHAIN iTNC 530 HSCI - Accessories

134 HEIDENHAIN Technical Manual iTNC 530 HSCI
Accessories
Accessories iTNC 530 HSCI
PL 6xxx PLC input/output
systems with HSCI
Up to eight PL 6xxx can be connected
 PL 620x (system PL)
• Necessary once for each control system (except with UEC)
• Has connections for TS and TT touch probes
• Safety-relevant inputs/outputs
• Available for 4, 6 or 8 I/O modules
 PL 610x (expansion PL)
• As addition to the system PL for increasing the number of
PLC inputs/outputs
• Available for 4, 6 or 8 I/O modules
 I/O modules
• PLD-H 16-08-00
I/O module with 16 digital inputs and 8 digital outputs
• PLD-H 08-16-00
I/O module with 8 digital inputs and 16 digital outputs
• PLA-H 08-04-04
I/O module with 8 x +/– 10 V inputs, 4 x +/- 10 V analog
outputs, 4 x PT 100 inputs
• Empty housing for slots of a PL
Power supply for HSCI
components
 PSL 13x
24 V power supply unit for supplying the HSCI components
• Outputs:
NC: 24 V– (double insulation)
PLC: 24 V– (basic insulation)
Per output: max. 21 A/ 500 W
Total: Max. 32 A / 750 W
• Outputs can be connected in parallel
Electronic handwheels  One portable HR 410, HR 520 handwheel, or
 One HR 550 handwheel with wireless transmission
 One HR 130 panel-mounted handwheel
 Up to three HR 150 via HRA 110
 Rotary encoder at position input can be configured as a
handwheel
Touch probes  TS 220 triggering 3-D touch probe with cable connection, or
 TS 440, TS 640, TS 642 three-dimensional touch trigger probe
with infrared transmission
 TT 449 for tool measurement