HEIDENHAIN iTNC 530 HSCI - Software Options

136 HEIDENHAIN Technical Manual iTNC 530 HSCI
Software options
Software options iTNC 530
#8: Software option 1
ID 367591-01
 Cylinder surface interpolation
 Feed rate in distance per minute
 Tilting the working plane
 Circular interpolation in 3 axes with tilted working plane
#9: Software option 2
ID 367590-01
 HSC path control:
• Cycle 32: Additional options in Cycle 32 for roughing and
finishing mode, and tolerances for rotary axes
 3-D compensation
• of the tool length and diameter via surface normal vectors
(DL/DR in the tool table)
• via radius compensation perpendicular to the tool direction
(RL/RR in the NC program)
• Programming with LN blocks (machine-neutral 3-D
programming with various options)
 3-D machining
• TCPM: Tool Center Point Management—Maintain position
of the tool tip when positioning with tilting axes (via M128 in
the NC program) and with additional options (via Function
TCPM in the NC program)
• M114: Automatic correction of machine geometry when
positioning tilting axes
• M144: Compensating the machine’s kinematic configuration
for ACTUAL/NOMINAL positions at end of block
 Keeping the tool normal to the contour
 Straight-line interpolation in 5 axes (export license required)
 Spline interpolation: Execution of splines (third-degree
polynomials)
Note: With software version 60642x-02 and higher, the fast block
processing time (0.5 ms) and all nominal position value filters (HSC
filters) are available as a standard feature without the need to
enable a software option.
#18: HEIDENHAIN DNC
ID 526451-01
 All functions of HEIDENHAIN DNC are available (see "Remo
Tools SDK" documentation)
 The following functions of the LSV2 ActiveX control become
available (all other options do not require option 18):
• OpenChatWindow
• RunProgram
• SetOverride
• SetPreset
• TransmitChatText
• TransmitPLCCommand
• TransmitPLCString
• HostFunction
• EventReceived
• NCMsgReceived
• PLCMsgReceived