HEIDENHAIN iTNC 530 HSCI - Module 9207 Replace PLC Soft Keys

1384 HEIDENHAIN Technical Manual iTNC 530 HSCI
Module 9207 Replace PLC soft keys
With Module 9207, individual PLC soft-keys can be replaced by another PLC
soft key. The change can be applied to the entire project file or only to an
individual menu. If a soft key is to be replaced in the entire project file, the
source menu is excepted from it so that the soft key can remain to make it
possible to reverse the replacement.
Call:
PS D <Resource handle>
Resource handle from Module 9203
PS B/W/D/K <PLC soft-key number source>
PS B/W/D/K <Number of PLC soft-key menu source>
PS B/W/D/K <PLC soft-key number target>
PS B/W/D/K <Number of soft-key menu target>
–1: Entire resource file except source menu
PS B/W/D/K <Function>
0: Replace soft key
CM 9207
Error code:
Marker Value Meaning
M4203 0 No error
1 Error code in W1022
W1022 2 Incorrect resource handle or incorrect function
20 Module was not called in a spawn or submit job
44 Error during setting of setup parameters