HEIDENHAIN iTNC 530 HSCI - Module 9182 Re-Enable Individual NC Keys; Module 9183 Disable Groups of NC Keys

1394 HEIDENHAIN Technical Manual iTNC 530 HSCI
Module 9182 Re-enable individual NC keys
With this module you cancel the effect of Module 9181.
Call:
PS B/W/D/K <Key code>
CM 9182
PL B/W/D <Error status>
0: NC key enabled
–1: For error see W1022
Error code:
Module 9183 Disable groups of NC keys
The key-group codes are:
 0: All keys
 1: ASCII
 2: Horizontal soft keys, Page Up/Down
 3: Cursor, ENT, NOENT, DEL, END, GOTO
 4: Numbers, algebraic signs, decimal point, actual position capture
 5: Operating modes
 6: Block opening keys
 7: Vertical soft keys, switch-over key
Call:
PS B/W/D/K <Key-group code>
CM 9183
PL B/W/D <Error status>
0: Group of NC keys disabled
–1: Transferred parameter > maximum value
Error code:
Marker Value Meaning
M4203 0 Disabling was canceled
1 Error code in W1022
W1022 1 Transferred parameter > maximum value
2 Transferred parameter invalid
Marker Value Meaning
M4203 0 The group of NC keys was disabled
1 Error code in W1022
W1022 2 Transferred parameter invalid