HEIDENHAIN iTNC 530 HSCI - Copying, Renaming or Deleting a File

1408 HEIDENHAIN Technical Manual iTNC 530 HSCI
Copying, renaming
or deleting a file
Module 9248 is used to copy, rename and delete files. This module can be
used to access all mounted drives.
Module 9248 Copy, rename and delete files
Any necessary file conversions (ASCII --> binary, binary --> ASCII) are
performed automatically during the copy process.
Conditions:
 The file names must contain drive information (e.g. PLC:) and file types.
 The file types are used to determine whether a conversion is necessary.
 If a conversion must be performed, then the file types must be identical.
 The file types are used to determine whether renaming is permissible. If the
file type remains the same during renaming, then there are no limitations. If
the file type is changed, then renaming is only permitted between certain
file types.
 Dependencies with other files are not considered when deleting files.
Call:
PS B/WD/K/S <Name of the source file>
PS B/W/D/K/S<Name of the target file>
Only with mode 0 or 1
PS B/W/D/K <Mode>
0: Copy
1: Rename
2: Delete
CM 9248
Error code:
Marker Value Meaning
M4203 0 Successful execution of module
1 Error code in W1022
W1022 2 Module was called in an invalid mode setting
3 Invalid source string or target string
7 Error during file conversion, invalid source or target
string, error during copying without file conversion, or
source file does not exist
20 Module was not called in a spawn or submit job
29 Copying or renaming not allowed for the current file
types
36 Error during renaming or deletion. More information
about the error can be requested with Module 9149,
immediately after Module 9248 has been called.
Or an error occurred during a copying process without
conversion.
Set Reset
W1018 Number of files opened by the PLC NC NC
W1020 Number of all open files NC NC