HEIDENHAIN iTNC 530 HSCI - Page 1460

1460 HEIDENHAIN Technical Manual iTNC 530 HSCI
Only for fixtures (*.cft table):
KEY  Var Page 8 – 1470
 VarParam Page 8 – 1470
 VarTp Page 8 – 1470
 VarEntry Page 8 – 1470
 TpRef Page 8 – 1464
 TpPos Page 8 – 1464
 TpAng Page 8 – 1464
 TpRefAng Page 8 – 1464
 TpCheck Page 8 – 1464
AXIS X, Y, Z, A, B, C ... Entry of the axis designation for function
given in the KEY column (valid for the
MachAxis, Trans and TPXxx parameters in
the KEY column).
RADIUS E.g. 40 [mm] Entry of the radius for "Cylinder"-type
collision-monitored objects in the KEY
column.
HEIGHT E.g. 150 [mm] Entry of the height for "Cylinder"-type
collision-monitored objects in the KEY
column.
COORD e.g. 47.092 [mm]
or 45.05 [°]
Entry of the transformation value for linear
axes (X, Y, Z, ...) in mm or for rotary axes
(A, B, C) in degrees. The units are not
entered. The iTNC infers the units from the
axis designation entered (valid for the
Trans parameter in the KEY column).
FILE Path and file
name
a
Entry of the path and file name of a
definition table for a collision-monitored
object (valid for the CMO parameter in the
KEY column).
DOC Designator Entry of a designator
Column Input Description