July 2013 8.6 DCM – Dynamic Collision Monitoring 1461
Only for fixtures (*.cft/*.cfx table):
X, Y, Z Position value Entry of a position shift in X, Y, Z for
"Cylinder" or "Cuboid"-type objects under
"Position" in KinematicsDesign.
Entry of the position at which the fixture is
to be probed during probing cycles.
XSIZE,
YSIZE,
ZSIZE
Dimensions Dimensions of a cube within a fixture file
NAME Name Name of a variable or a probing cycle
FUNC Function Function for determining the value of a
variable from a manual probing cycle, see
page 1469
VALUE Value Value of a variable, see page 1470
RANGE Value range Permissible value range of a variable with
manual input field.
e.g. "1...10"; "100..."; "...5, 10...15, -20"
SUBTYPE Format Format of a variable with manual input
field, see page 1470.
DEFINCH Value in inches This is the default value for the variable
when "Inch" is set. Only for linear input,
see page 1470.
PICTURE Help graphic File with help graphic for a variable or a
variable subfixture, see page 1470.
LABELID Label text Plain language or text ID for a variable, see
page 1470.
a. File paths in *.cft and *.cfx files must be entered relative to the
active file.
Column Input Description
To Next Page
Loading...
