HEIDENHAIN iTNC 530 HSCI - Page 1472

1472 HEIDENHAIN Technical Manual iTNC 530 HSCI
Variable of the type Wizard parameter as example:
In this example fixture the distance between the jaws is to be variable, and the
operator must be able to enter this information in the FixtureWizard. Proceed
as follows:
 Insert a variable of the type Wizard parameter, and enter a designation for
the variable under Name. Under Value range, enter the permissible input
range for the variable.
 Enter a default value for the variable in the Value field.
 You also have the option of entering a help graphic and a label text, which
aids the operator when entering the parameters in the FixtureWizard.
 In this example the distance between jaws is to be variable. Therefore, the
transformation that determines the position of the rear jaw must be linked
to the variable. In this example, the result of 40.0 + VarDist indicates the
position of the rear jaw. The fixed value 40 determines the position of the
rear jaw when VarDist = 0 in the example.