1482 HEIDENHAIN Technical Manual iTNC 530 HSCI
COORD E.g. 47.092 [mm]
or 45.05 [°]
Entry of the transformation value for linear
axes (X, Y, Z, ...) in mm or for rotary axes
(A, B, C) in degrees. The units are not
entered. The iTNC infers the units from the
axis designation entered (valid for the
Trans parameter in the KEY column).
FILE Path and file
name
a
Entry of the path and file name of a
definition table for a collision-monitored
object (valid for the CMO parameter in the
KEY column).
DOC Designator Entry of a designator
X, Y, Z Position value Entry of a position shift in X, Y, Z for
"Cylinder" or "Cuboid"-type objects under
"Position" in KinematicsDesign.
XSIZE,
YSIZE,
ZSIZE
Dimensions Dimensions of a cube within a tool-carrier
kinematics description
NAME Name Name of a variable
VALUE Value Value of a variable, see page 1483
RANGE Value range Permissible value range of a variable with
manual input field.
e.g. "1...10"; "100..."; "...5, 10...15, -20"
SUBTYPE Format Format of a variable with manual input
field, see page 1483.
DEFINCH Value in inches This is the default value for the variable
when "Inch" is set. Only for linear input,
see page 1483.
PICTURE Help graphic File with a help graphic for a variable, see
page 1483
LABELID Label text Plain language or text ID for a variable, see
page 1483.
a. File paths in *.cft and *.cfx files must be entered relative to the
active file.
Column Input Description
To Next Page
Loading...
