1496 HEIDENHAIN Technical Manual iTNC 530 HSCI
Markers and
machine
parameters
Settings possibilities for markers and machine parameters
MP7683 Executing pallet tables and NC programs
Format: %xxxxxxxxx
Input: Bit 0 – PROGRAM RUN, SINGLE BLOCK operating mode:
0: During the start, a line of the NC program is run. The pallet
change macro is executed completely.
1: During the start, a complete NC program is run.
Bit 1 – PROGRAM RUN, FULL SEQUENCE operating mode:
0: NC start executes a complete NC program.
1: At the start all NC programs are executed up to next pallet.
Bit 2 – PROGRAM RUN, FULL SEQUENCE operating mode:
0: As defined in bit 1
1: All NC programs and pallets up to the end of the table are
executed.
Bit 3 – When the end of the table is reached, the process begins
again with the first line.
0: Function is not in effect
1: Function is effective (bit 2 = 1)
Bit 4 – Editing the active pallet table
0: Active pallet table cannot be edited.
1: The active pallet can be edited in the PROGRAM RUN, FULL
SEQUENCE and PROGRAM RUN, SINGLE BLOCK modes.
Bit 6 – Display of pallet table and NC program
0: Both simultaneously in a split screen
1: Pallet table or NC program individually
Bit 7 – AUTOSTART function
0: AUTOSTART by the NC
1: AUTOSTART by the PLC
Bit 8 – Procedure for tool-oriented machining in the Program Run
operating modes
0: NC start machines all workpieces on the pallet until the next
tool change
1: NC start executes all NC programs until the end of the pallet
Bit 9 – Editing of pallet tables
0: EDIT PALLET soft key is not displayed
1: EDIT PALLET soft key is displayed
Set Reset
M4160 Pallet table selected NC NC
M4196 Pallet machining stopped for lack of a
valid job
NC PLC
To Next Page
Loading...
