July 2013 8.8 Electronic handwheel 1517
Settings Set MP7640 to 11 or 13, depending on whether you want to use the LEDs
of the HR 520.
In MP7641, specify whether you are using an HR 5x0 with or without
detent, and whether the keys on the handwheel are to be evaluated by the
NC or PLC.
All settings that can be defined in the machine parameters of the HR 420 can
also be used for the HR 520. The PLC markers of the HR 420 also match those
of the HR 520.
The six LEDs of the HR 5x0 can be controlled by the specified PLC markers.
F1 F2 F3 F4 F5
XYZ
IV V VI
↑ Handwhee
l active/
inactive
↓
–
(M4667)
Rapid
traverse
(M4663)
+
(M4666)
Spindle
start
(M4664)
LED
(M4684)
Actual
position
capture
LED
(M4689)
NC start
(M4661)
LED on
(M4681)
Spindle
stop
(M4665)
LED
(M4685)
Ctrl
(M4668)
LED
(M4688)
NC stop
(M4662)
LED
(M4682)
To Next Page
Loading...
