HEIDENHAIN iTNC 530 HSCI - Page 1570

1570 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP7266.25 Tool material TMAT 16 characters 16 STRING
MP7266.26 Cutting data table CDT 16 characters 16 STRING
MP7266.27 PLC value PLC-VAL ±99999.9999 11 FLOAT
MP7266.28 Probe center misalignment in ref.
axis
CAL-OF1 ±99999.9999 11 FLOAT
MP7266.29 Probe center misalignment in
minor axis
CAL-OF2 ±99999.9999 11 FLOAT
MP7266.30 Spindle angle during calibration CAL-ANG 0.0 – 360.0000 8 FLOAT
MP7266.31 Tool type for pocket table PTYP 0 – 99 2 UINT
MP7266.32 Maximum shaft speed [rpm] NMAX - or 0 – 999999 6 FLOAT
MP7266.33 Retract tool LIFTOFF Y or N 2 String
MP7266.34 PLC value
Input range:
–99999.9999 to +99999.9999
P1 ±99999.9999 11 FLOAT
MP7266.35 P2 ±99999.9999 FLOAT
MP7266.36 P3 ±99999.9999 FLOAT
MP7266.37 Additional kinematics description
for tool and tool carrier
KINEMATI
C
16 characters 16 STRING
MP7266.38 Point angle for DRILL and CSINK T-ANGLE ±180.0000 9 FLOAT
MP7266.39 Thread pitch for TAP PITCH 0 – 99999.99 10 FLOAT
MP7266.40 Control strategy name for AFC
(Adaptive Feed Control)
AFC 10 characters 10 String
MP7266.41 Tool value or tool radius R2 R2TOL 0 – 0.9999 5 FLOAT
MP7266.42 Compensation value table for
3DToolComp
DR2TABL
E
16 characters 16 STRING
MP7266.43 Time stamp during tool changing LAST_US
E
16 characters 16 STRING
MP7266.44 Active Chatter Control on/off ACC ’0’ or ’1’ 2 UINT
a. In SW 606 42x-02 increased from 16 to 32 characters
b. In SW 606 42x-02 increased from ±99.9999 [mm/inch] to ±999.9999 [mm/inch]
MP Meaning Column
name
Value range Column
width
Data type