HEIDENHAIN iTNC 530 HSCI - Module 9096 Delete a Line from the Tool Table

July 2013 8.15 Tool changer 1577
Module 9096 Delete a line from the tool table
You remove a line from the tool table and cancel any link with a replacement
tool.
The module must be called in a submit job or spawn job.
Call:
PS B/W/D/K <Tool number / pocket number>
PS B/W/D/K <Mode>
Bit 0: Delete entries in pocket table
0: Pocket table remains unchanged
1: Tool number in pocket table is deleted
Bit 1: Tool or pocket number
0: Transferred value = tool number
1: Transferred value = pocket number
CM 9096
Error code:
Marker Value Meaning
M4203 0 Line was deleted
1 Error code in W1022
W1022 2 Invalid pocket or tool number
21 Module was not called in a spawn or submit job
24 File error