HEIDENHAIN iTNC 530 HSCI - Search Sequence of the Tool Magazines

July 2013 8.15 Tool changer 1591
Search sequence of
the tool magazines
Sequence for searching in tool magazines for the tool to be called. To call a tool
through tool names, it is possible in machine parameter 7484.0 to .15 to
specify a sequence (index from MP7261, or –1 cancel) for searching in tool
magazines. If several tools are available in the magazine and a tool usage list
is available, the tool with the shortest sufficient service life is chosen. If the
tool is not found in any given magazine, the first tool with sufficient service life
from the TOOL.T file is used.
MP7484.x Search sequence in tool magazines
Input: 0 to 15 [index from MP7261]
–1 = Cancel
Module 9301 Find the number of an entry in the pocket table
Module 9301 determines the number of an entry in the pocket table. This
number is necessary for the modules in which no tool magazine numbers can
be entered.
Call:
PS B/W/D/K <Tool magazine number>
PS B/W/D/K <Pocket number>
CM 9301
PL B/W/D <Number of the entry in the pocket table>
–1: M4203 = 1
Error code:
Module 9302 Search for a vacant pocket in the tool magazine
Module 9302 searches for a vacant pocket in a tool magazine.
Call:
PS B/W/D/K <Tool magazine number>
PS B/W/D/K <Pocket at which the search is to be started>
CM 9302
PL B/W/D <Number of the vacant pocket>
–1: No vacant pocket available
Error code:
Marker Value Meaning
M4203 0 Number of the entry was found
1 Error code in W1022
W1022 1 Invalid tool magazine number
2 Invalid pocket number
20 Module was not called in a submit or spawn job
Marker Value Meaning
M4203 0 Search completed
1 Error code in W1022
W1022 1 Invalid pocket number
2 Invalid tool magazine number
20 Module was not called in a spawn job or submit job
36 Error in file handling