HEIDENHAIN iTNC 530 HSCI - Page 1717

July 2013 9.5 Data Transfer NC > PLC, PLC > NC 1717
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System datum
Switch the spindle
20 13 – 0 = spindle 1
1 = spindle 2
18 – Second axis-specific rapid traverse
Data from the tool table
50 1 Tool no. Tool length L
2 Tool no. Tool radius R
3 Tool no. Tool radius R2
4 Tool no. Oversize for tool length DL
5 Tool no. Oversize for tool radius DR
6 Tool no. Oversize for tool radius DR2
7 Tool no. Tool locked TL
0 = not locked, 1 = locked
8 Tool no. Number of the replacement tool RT
9 Tool no. Maximum tool age TIME1
10 Tool no. Maximum tool age TIME2
11 Tool no. Current tool age CUR. TIME
12 Tool no. PLC status
13 Tool no. Maximum tooth length LCUTS
14 Tool no. Maximum plunge angle ANGLE
15 Tool no. TT: Number of tool teeth CUT
16 Tool no. TT: Wear tolerance for length LTOL
17 Tool no. TT: Wear tolerance for radius RTOL
18 Tool no. TT: Direction of rotation DIRECT
0 = positive, –1 = negative
19 Tool no. TT: Offset in plane R-OFFS
R = 99999.9999
20 Tool no. TT: Offset for length L-OFFS
21 Tool no. TT: Break tolerance for length
LBREAK
22 Tool no. TT: Break tolerance for RBREAK
radius
23 Tool no. PLC value
24 Tool no. Probe-center offset in reference axis
CAL-OF1
25 Tool no. Probe-center offset in minor axis
CAL-OF2
26 Tool no. Spindle angle for calibration
CAL-ANG