HEIDENHAIN iTNC 530 HSCI - Page 1726

1726 HEIDENHAIN Technical Manual iTNC 530 HSCI
Cycle parameters
30 1 – Set-up clearance
2 – Hole depth / milling depth
3 – Infeed depth
4 – Feed rate for plunging
5 – First side length of pocket
6 – Second side length of pocket
7 – First side length of slot
8 – Second side length of slot
9 – Radius of circular pocket
10 – Feed rate for milling
11 – Rotational direction of the milling path
12 – Dwell time
13 – Thread pitch
14 – Finishing allowance
15 – Roughing angle
52 <no.> Interrogation whether Q-parameter
number <no.> contains a string or
numerical value:
0 = tool number
1 = tool name
Data from the tool table
50 1 Tool no. Tool length L
2 Tool no. Tool radius R
3 Tool no. Tool radius R2
4 Tool no. Oversize for tool length DL
5 Tool no. Tool radius oversize DR
6 Tool no. Tool radius oversize DR2
7 Tool no. Tool locked TL
0 = Not locked, 1 = Locked
8 Tool no. Number of the replacement tool RT
9 Tool no. Maximum tool age TIME1
10 Tool no. Maximum tool age TIME2
11 Tool no. Current tool age CUR. TIME
12 Tool no. PLC status
13 Tool no. Maximum tooth length LCUTS
14 Tool no. Maximum plunge angle ANGLE
15 Tool no. TT: Number of tool teeth CUT
Group
name
Group
number
ID....
System data
number
NR....
System data
index
IDX....
System datum