1878 HEIDENHAIN Technical Manual iTNC 530 HSCI
Automount Select whether the drive is to be connected automatically during
control start-up if a network connection exists.
Expert Options These settings are only intended for your network specialists.
Inspection Summary of the settings made.
Please check the settings before saving them with the Apply
button. You can later change the settings using the Edit button.
Remove Remove the selected network drive from the list.
Copying Copy the data of the selected network drive and insert it in the list as a new entry.
Editing Edit the settings of the selected network drive (see Add).
Status Log:
The Status Log window provides various information during the connection of a
network drive. This information assists you in troubleshooting if a network drive
cannot be connected, for example.
The following screen buttons are available in the Status Log window:
Delete Delete the contents of the Status Log window.
The following screen buttons are available in the Mount Setup window:
OK Accept the changes and exit the network settings.
Apply Load the changes.
Cancel Exits the network settings. The changes made are discarded.
Screen
button /
soft key
Screen button /
soft key
Meaning
To Next Page
Loading...
