July 2013 10.9 Saving and Loading Files 1915
To write to or read from machine parameter files, compensation tables or PLC
files, you must enter the correct code numbers with the MOD function:
You can output the current values of Q parameters, PLC error messages and
dialogs over the RS-422/V.11 and RS-232-C/V.24 interfaces. (NC program: FN
15: PRINT).
During transmission with a Block Check Character (BCC), each device outputs
and receives the correct file code.
Example:
If a pallet table is stored, it is given the file extension *.LNC.
For data transmission with the TNCremoNT PC software from HEIDENHAIN
the identifier has no significance. The files are saved on the PC with the same
extension as on the iTNC.
Files that have no code (-) can only be transmitted with the LSV2 protocol
of TNCremoNT.
To Next Page
Loading...
