July 2013 10.11 External Programming 1929
10.11 External Programming
Please remember the following when programming externally for subsequent
transmission:
At the program beginning and after every program block, <CR><LF> or
<LF> must be programmed.
After the End of Program block, <CR><LF> and also <EXT> must be
programmed.
For NC programs, the spaces can be omitted between the individual words.
When reading-in DIN blocks, the asterisk character (*) is not required at the
end of the block.
Comments are separated from the NC block with a semicolon (;).
Comments located before the program are not saved.
With conversational programming, the block numbers are generated by the
iTNC. They need not be programmed.
To Next Page
Loading...
