HEIDENHAIN iTNC 530 HSCI - Data Interfaces - X26, X116: Ethernet Interface RJ45-Port

July 2013 3.28 Data interfaces 325
3.28 Data interfaces
X26, X116: Ethernet
interface RJ45-port
 Maximum cable length:
• Unshielded: 100 m
• Shielded: 400 m
 Network topology: Star configuration
A hub serves as a central node that establishes the connection to the other
participants.
Maximum data transfer rate:
 For integration into the company network via NFS or SMB protocol:
Up to 1 Gbit/s
 For LSV2 protocol (in conjunction with TNCremoNT or RemoTools):
2 to 5 Mbps (depending on file type and network utilization)
Assignment with 100 Mb Ethernet interface:
Assignment with 1 Gbit Ethernet interface (available on all current MCs):
Danger
The Ethernet interfaces of the MC 6xxx or MC 7xxx comply with the
requirements of PELV ("low voltage electrical separation") according to
EN 61800-5-1 and are powered internally by 24 V NC. All devices connected
to these Ethernet interfaces must comply with the requirements of SELV
or PELV according to EN 61800-5-1.
RJ45 connection (female) 8-pin Assignment
1TX+
2TX–
3RX+
4 Do not assign
5 Do not assign
6RX–
7 Do not assign
8 Do not assign
Housing External shield
RJ45 connection (female) 8-pin Assignment
1MX0+
2MX0–
3MX1+
4MX2+
5MX2–
6MX1–
7MX3+
8MX3–
Housing External shield