348 HEIDENHAIN Technical Manual iTNC 530 HSCI
X30: Permissive
button,
EMERGENCY STOP
on handwheel
Pin layout of PLB 6001 FS:
X31: Permissive
button/NC-start,
NC-stop
Connection X31 of PLB 6001:
X31 pin layout on PLB 6001 FS:
Connecting
terminals
Assignment
1 Permissive button channel A / terminal 1 (+24 V NC)
2 Permissive button channel A / terminal 2
3 Permissive button channel B / terminal 1 (+24 V NC)
4 Permissive button channel B / terminal 2
5 Emergency stop channel A / supply for channel A (–TEST.A)
6 Emergency stop channel A / terminal 2
7 Emergency stop channel B / supply for channel B (–TEST.B)
8 Emergency stop channel B / terminal 2
Connecting
terminals
Assignment
1 Reserved (do not use)
2 Reserved (do not use)
3 Reserved (do not use)
4 Reserved (do not use)
5 NC start
6 Reserved (do not use)
7 NC start power supply (+24 V NC)
8NCstop
9 Reserved (do not use)
10 NC stop power supply (+24 V NC)
Connecting
terminals
Assignment
1 Optional: Permissive button channel A / terminal 1 (+24 V)
2 Optional: Permissive button channel A / terminal 2
3 Optional: Permissive button channel B / terminal 1 (+24 V)
4 Optional: Permissive button channel B / terminal 2
5 NC start channel A / terminal 1
6 NC start channel B / terminal 2
7 NC start shared terminal (+24 V NC)
8 NC stop channel A / terminal 1
9 NC stop channel B / terminal 2
10 NC stop shared terminal (+24 V NC)
To Next Page
Loading...
