HEIDENHAIN iTNC 530 HSCI - List of Machine Parameters; Encoders and Machines

494 HEIDENHAIN Technical Manual iTNC 530 HSCI
4.4 List of machine parameters
4.4.1 Encoders and machines
MP Function and input Software
version and
behavior
Page
MP10 Active axes
Format: %xxxxxxxxxxxxxxxxxx
Input: Bits 0 to 17 represent axes 1 to 18
0: Axis not active
1: Axis active
PLC
RUN
603
MP12 Axis-specific demo operation for NC axes
Format: %xxxxxxxxxxxxxxxxxx
Input: Bits 0 to 17 represent axes 1 to 18
0: Demo operation not active
1: Demo operation active
PLC
RUN
604
MP20 Monitoring functions for the axes
Format: %xxxxxxxxxxxxxxxxxx
Input: Bits 0 to 17 represent axes 1 to 18
0: Monitoring not active
1: Monitoring active
PLC
RUN
610
MP20.0 Absolute position of the distance-coded reference marks
MP20.1 Amplitude of encoder signals
MP20.2 Edge separation of encoder signals
MP21 Monitoring functions for the spindle
Format: %xx
Input: Bit 0 – Spindle 1
0: Monitoring not active
1: Monitoring active
Bit 1 – Spindle 2
0: Monitoring not active
1: Monitoring active
PLC
RUN
610
MP21.0 Absolute position of the distance-coded reference marks
MP21.1 Amplitude of encoder signals
MP21.2 Edge separation of encoder signals
MP100 Designation of axes
Format: -wvucbazyxWVUCBAZYX
Any lowercase letters for auxiliary axes,
any uppercase letters for slave axes
Input: Characters 1 to 9 from the right represent
axes 1 to 18
PLC
RUN
603,
630
MP100.0 Traverse range 1
MP100.1 Traverse range 2
MP100.2 Traverse range 3