July 2013 4.4 List of machine parameters 503
MP1085.x Maximum permissible axis-specific jerk for path
movements in the operating modes Program Run Full
Sequence, Program Run Single Block, and Positioning with
Manual Data Input
Input: 0.0 to 9999.9 [m/s
3
or 1000° /s
3
]
818
MP1086.x Maximum permissible axis-specific jerk for rapid traverse
movements in the operating modes Program Run Full
Sequence, Program Run Single Block, and Positioning with
Manual Data Input
Input: 0: Function inactive
0.0 to 9999.9 [m/s
3
or 1000° /s
3
]
PLC
RUN
818
MP1087.x Maximum permissible axis-specific jerk for Manual
operating mode
Input: 0.1 to 1000.0 [m/s
3
or 1000° /s
3
]
PLC
RUN
818
MP1088.x Axis-specific jerk limiting for unfiltered positioning
movements
Input: 0.1 to 9999.9 [m/s
3
or 1000° /s
3
]
818
MP1089.x Max. permissible axis-specific jerk for Pass Over Reference
Point mode
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
PLC
RUN
818
MP1090 Maximum permissible jerk on the tool path
Input: 0: Not active
0.0 to 9999.9 [m/s
3
or 1000° /s
3
]
PLC
RUN
818
MP1090.0 For movements not at rapid traverse or feed rate < MP1092
MP1090.1 For movements at rapid traverse or feed rate > MP1092
MP1092 Feed rate threshold for MP1085.x and MP1086.x
Input: 1 to 300 000 [mm/min] (previous behavior)
0: Not active
PLC
RUN
818
MP1094 HSC filter (no longer recommended with HSCI, improved
nominal position value filters as of MP12xx)
Input: 0: HSC filter inactive
0.1 to 166.0: Cutoff frequency for HSC filter
Only
through
MPMODE =
340422 in
OEM.SYS
MP1095 Nominal position value filter (no longer recommended with
HSCI, improved nominal position value filters as of MP12xx)
Input: 0: Single filter
1: Double filter
PLC
RUN
Only
through
MPMODE =
340422 in
OEM.SYS
MP1095.0 In the Program Run Full Sequence, Program Run Single
Block, and Positioning With Manual Data Input operating
modes
MP1095.1 In the Manual, Handwheel, Jog Increment and Pass Over
Reference Point operating modes
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
