HEIDENHAIN iTNC 530 HSCI - HSCI adapter PLB 6001

504 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP1096 Tolerance for contour transitions at corners (no longer
recommended with HSCI, improved nominal position value
filters as of MP12xx)
Input: 0: No nominal position value filter
0.001 to 3.000 [mm]
PLC
RUN
Only
through
MPMODE =
340422 in
OEM.SYS
,
MP1096.0 With machining feed rate
MP1096.1 With rapid traverse
MP1097.x Max. permissible axis-specific jerk (single filter / HSC filter)
(no longer recommended with HSCI, improved nominal
position value filters as of MP12xx)
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
PLC
RUN
Only
through
MPMODE =
340422 in
OEM.SYS
MP1098.x Max. permissible axis-specific jerk (double filter / HSC filter)
(no longer recommended with HSCI, improved nominal
position value filters as of MP12xx)
Input: 0.1 to 1000.0 [m/s
3
or 1000°/s
3
]
PLC
RUN
Only
through
MPMODE =
340422 in
OEM.SYS
MP1099 Minimum filter order (no longer recommended with HSCI,
improved nominal position value filters as of MP12xx)
Input: 0 to 20
PLC
RUN
Only
through
MPMODE =
340422 in
OEM.SYS
MP1099.0 Minimum filter order for single filter (MP1095 = 0)
MP1099.1 Minimum filter order for double filter (MP1095 = 1)
MP1110.x Standstill monitoring
Input: 0.0010 to 30.0000 [mm]
PLC
RUN
900
MP1120.x Standstill monitoring when determining the field angle
Input: 0.0000 to 300.0000 [mm] or [°]
PLC
RUN
1019
MP1140.x Threshold above which the movement monitoring
functions
Input: Analog axes: 0.030 to 10.000 [V]
Digital axes: 0.030 to 10.000 [1000 min]
Recommended: 0.030 [1000 min]
PLC
RUN
899
MP1144.x Motion monitor for position and speed
Input: Analog axes: Without function
Digital axes: 0 to 99 999.999 [mm]
0: No monitoring
PLC
RUN
899
MP Function and input Software
version and
behavior
Page