HEIDENHAIN iTNC 530 HSCI - Encoders

July 2013 4.4 List of machine parameters 511
4.4.4 Servo control with following error
MP Function and input Software
version and
behavior
Page
MP1710.x Position monitoring for operation with following error
(erasable)
Input: 0.0000 to 300.0000 [mm]
Recommended: 1.2 ⋅ following error
PLC
RUN
896
MP1720.x Position monitoring for operation with following error
(emergency stop)
Input: 0.0000 to 300.0000 [mm]
Recommended: 1.4 ⋅ following error
PLC
RUN
896
MP1810.x k
V
factor for control with following error
Input: 0.100 to 20.000 [(m/min)/mm]
PLC
RUN
834
MP1815.x k
V
factor for control with following error effective after
M105
Input: 0.100 to 20.000 [(m/min)/mm]
PLC
RUN
834
MP1820.x Multiplier for the k
V
factor
Input: 0.001 to 1.00000
PLC
RUN
843
MP1830.x Characteristic curve kink point
Input: 0.000 to 100.000 [%]
PLC
RUN
843