HEIDENHAIN iTNC 530 HSCI - Page 529

July 2013 4.4 List of machine parameters 529
MP3450.0-7 Number of spindle position-encoder revolutions for gear
ranges 1 to 8
Input: 0 to 65 535
0: No transmission
PLC
RUN
948
MP3451.0-7 Number of spindle revolutions for gear ranges 1 to 8
Input: 0 to 65 535
0: No transmission
PLC
RUN
948
MP3510.0-7 Rated speed for the gear ranges 1 to 8
Input: 0 to 99 999.999 [min
–1
]
PLC
RUN
958
MP3515.0-7 Maximum spindle speed for gear ranges 1 to 8
Input: 0 to 99 999.999 [min
–1
]
PLC
RUN
962
MP3520.0 Speed activation through marker M4011
Input: 0 to 99 999.999 [min
–1
]
PLC
RUN
973,
970
MP3520.1 Spindle speed for oriented stop
Input: 0 to 99 999.999 [min
–1
]
MP3530 Increased spindle power for roughing
Input: 0 = Not active
1 = Increased spindle power for roughing
956
MP3540 Permissible spindle speed shortfall
Input: 0.001 to 0.999
0: Monitoring not active
956
MP3542 Minimum spindle speed as of which the monitoring in
MP3540 becomes active
Input: 0.001 to 0.999
0: Monitoring not active
956
MP3550 Delay of emergency-stop reaction of spindles
Input: 0.001 to 0.100 [s]
0: Delay not active
872
MP Function and input Software
version and
behavior
Page