July 2013 4.4 List of machine parameters 537
4.4.10 Tool measurement with TT
MP Function and input Software
version and
behavior
Page
MP6500 Tool measurement with TT 130
Format: %xxxxxxxxxxxxxxx
Input: Bit 0 – Cycles for tool measurement
0: Disabled
1: Not disabled
Bit 1 –
0: Tool radius measurement allowed. Tool length
measurement with rotating spindle
1: Tool radius measurement and individual tooth
measurement disabled
Bit 2 –
0: Tool length measurement with stationary spindle (bit
1=1)
1: Tool length measurement with rotating spindle, only if a
tool radius offset (TT: R-OFFS) has been entered
in the tool table
Bit 3 –
0: Tool measurement with spindle orientation
1: Tool measurement without spindle orientation. Individual
tooth measurement not possible. Tool radius
measurement possibly faulty
Bit 4 –
0: Automatically determine speed
1: Always use minimum spindle speed
Bit 5 – NC stop during tool checking
0: The NC program is not stopped when the breakage
tolerance is exceeded
1: If the breakage tolerance is exceeded, the NC program is
stopped and the error message Tool broken is
displayed
Bit 6 – NC stop during tool measurement
0: The NC program is not stopped when the breakage
tolerance is exceeded
1: If the breakage tolerance is exceeded, the NC program is
stopped and the error message Touch point
inaccessible is displayed
PLC
RUN
1552,
1553,
1555,
1557,
1559,
1559
To Next Page
Loading...
