HEIDENHAIN iTNC 530 HSCI - Page 548

548 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP7266.34 PLC value (P1)
MP7266.35 PLC value (P2)
MP7266.36 PLC value (P3)
MP7266.37 Additional kinematics description (KINEMATIC)
MP7266.38 Point angle for DRILL and CSINK (T-ANGLE)
MP7266.39 Thread pitch for TAP (PITCH)
MP7266.40 Control strategy name for AFC (Adaptive Feed Control)
MP7266.41 Tolerance value or tool radius R2 (R2TOL)
MP7266.42 Compensation value table for 3DToolComp (DR2TABLE)
MP7266.43 Time stamp during tool changing (LAST_USE)
MP7266.44 Active Chatter Control on/off (ACC)
MP7267 Elements of the pocket table
MP7267 can also be overwritten by the PLC and the LSV2
protocol.
Input: 0: No display
1 to 99: Position in the pocket table
CN123 1571
MP7267.0 Tool number (T)
MP7267.1 Special tool (ST)
MP7267.2 Fixed pocket (F)
MP7267.3 Locked pocket (L)
MP7267.4 PLC status (PLC)
MP7267.5 Tool name (TNAME)
MP7267.6 Comment on the tool (DOC)
MP7267.7 Tool type for pocket table (PTYP)
MP7267.8 Value 1 (P1)
MP7267.9 Value 2 (P2)
MP7267.10 Value 3 (P3)
MP7267.11 Value 4 (P4)
MP7267.12 Value 5 (P5)
MP7267.13 Reserve pocket (RSV)
MP7267.14 Pocket above locked (LOCKED_ABOVE)
MP7267.15 Pocket below locked (LOCKED_BELOW)
MP7267.16 Pocket at left locked (LOCKED_LEFT)
MP7267.17 Pocket at right locked (LOCKED_RIGHT)
MP7267.18 S1 value (P6)
MP7267.19 S2 value (P7)
MP7268 Sorting/hiding columns of the preset table
Input: 1 to 99 = Order of the columns
0: Do not display the column
PLC
RUN
CN123
1209
MP Function and input Software
version and
behavior
Page