July 2013 4.4 List of machine parameters 549
MP7270 Feed rate display in the operating modes MANUAL
OPERATION and ELECTRONIC HANDWHEEL
Input: 0: Display of axis feed rate through pressing an
axis direction key (axis-specific feed rate from
MP1020)
1: Display of axis feed rate also before an axis direction key
is pressed (smallest value from MP1020 for all
axes)
PLC
RUN
CN123
1156
MP7280 Decimal character
Input: 0: Decimal comma
1: Decimal point
PLC
RUN
CN123
1285
MP7281 Depiction of the NC program
Input: 0: All blocks completely
1: Current block completely, others line by line
2: All blocks line by line; complete block when editing
PLC
RUN
CN123
1212
MP7285 Tool length offset in the tool-axis position display
Input: 0: Tool length is not offset
1: Tool length is offset
PLC
RUN
CN123
1148
MP7289 Position display step for the spindle
Input: 0: 0.1°
1: 0.05°
2: 0.01°
3: 0.005°
4: 0.001°
5: 0.0005°
6: 0.0001°
PLC
RUN
CN123
1148
MP7290.0-8 Position display step for axes 1 to 18
Input: 0: 0.1 mm or 0.1°
1: 0.05 mm or 0.05°
2: 0.01 mm or 0.01°
3: 0.005 mm or 0.005°
4: 0.001 mm or 0.001°
5: 0.0005 mm or 0.0005°
6: 0.0001 mm or 0.0001°
PLC
RUN
CN123
1148
MP7291 Display of axes on the screen
Format: SXYZABCUVWxyzabcuvw-
Input: Characters 1 to 9 from the right represent lines 1
to 9
Character 10 is spindle S which is always output in line 10.
PLC
RUN
603
MP7291.0 Display in traverse range 1
MP7291.1 Display in traverse range 2
MP7291.2 Display in traverse range 3
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
