July 2013 4.4 List of machine parameters 551
MP7310 Graphic display mode
Format: %xxxxxxxx
Input: Bit 0 – Projection in three planes:
0: German-preferred projection
1: US-preferred projection
Bit 1 – Rotating the coordinate system in the working plane
by 90°:
0: No rotation
1: Rotation by +90°
Bit 2 – BLK form after datum shift:
0: Shifted
1: Not shifted
Bit 3 – Display of the cursor position:
0: Not displayed
1: Displayed
Bit 4 – Reserved
Bit 5 – 3-D graphics during program test
0: 2.5-D and 3-D (only with MC 420 or MC 422B and higher)
1: 2.5-D
Bit 6 – Stock removal with an inclined tool
0: Not active
1: Active
Bit 6 – Exact evaluation of the column LCUTS (cutting
length) from the TOOL.T table in order to display
special tools (e.g. saw blade).
0: Free evaluation
1: Exact evaluation for special tools
PLC
RUN
CN123
1276
MP7312 Limitation of the tool tooth length LCUTS if no value was
given for the tooth length in the tool table
Input: = 0: No limitation, infinitely long tooth length
> 0: Tooth length = 2 * tool radius * MP7312
PLC
RUN
1563
MP7315 Tool radius for graphic simulation without TOOL CALL
Input: 0.0000 to 99 999.9999 [mm]
PLC
RUN
CN123
1563
MP7316 Penetration depth of the tool
Input: 0.0000 to 99 999.9999 [mm]
PLC
RUN
CN123
1563
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
