562 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP7481.x Sequence for new and returned tool when changing tools
Format: %xxxxxxxx
0: First, output the pocket of the tool to be returned
1: First, output the pocket of the new tool
Input: Bit 0: New tool from magazine 1
Bit 1: New tool from magazine 2
Bit 2: New tool from magazine 3
Bit 3: New tool from magazine 4
Bit 4: New tool from magazine 5
Bit 5: New tool from magazine 6
Bit 6: New tool from magazine 7
Bit 7: New tool from magazine 8
Bit 8: New tool from magazine 9
Bit 9: New tool from magazine 10
Bit 10: New tool from magazine 11
Bit 11: New tool from magazine 12
Bit 12: New tool from magazine 13
Bit 13: New tool from magazine 14
Bit 14: New tool from magazine 15
Bit 15: New tool from magazine 16
PLC
RUN
1614
MP7481.0 Tool from magazine 1 to be returned
MP7481.1 Tool from magazine 2 to be returned
MP7481.2 Tool from magazine 3 to be returned
MP7481.3 Tool from magazine 4 to be returned
MP7481.4 Tool from magazine 5 to be returned
MP7481.5 Tool from magazine 6 to be returned
MP7481.6 Tool from magazine 7 to be returned
MP7481.7 Tool from magazine 8 to be returned
MP7481.8 Tool from magazine 9 to be returned
MP7481.9 Tool from magazine 10 to be returned
MP7481.10 Tool from magazine 11 to be returned
MP7481.11 Tool from magazine 12 to be returned
MP7481.12 Tool from magazine 13 to be returned
MP7481.13 Tool from magazine 14 to be returned
MP7481.14 Tool from magazine 15 to be returned
MP7481.15 Tool from magazine 16 to be returned
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
