July 2013 4.4 List of machine parameters 563
MP7482 Pocket coding of the tool magazines
Format: %xxxxxxxx
0: Variable pocket coding
1: Fixed pocket coding
Input: Bit 0: Magazine 1
Bit 1: Magazine 2
Bit 2: Magazine 3
Bit 3: Magazine 4
Bit 4: Magazine 5
Bit 5: Magazine 6
Bit 6: Magazine 7
Bit 7: Magazine 8
PLC
RUN
1604
MP7483 Tool name/number for TOOL CALL / TOOL DEF
Input: 0: Names and numbers are permitted (as before)
1: Only names are permitted
2: Only numbers are permitted
1611
MP7484.x Search sequence in tool magazines
Input: 0 to 15 [Index aus MP7261]
–1: Cancel
1591
MP7485 Add usage time for tool selection
Input: 0 to 100 [%]
Default setting: 10
1597
MP7490 Functions for traverse ranges
Format: %xxxx
Input: Bit 0 –
0: Display one traverse range with MOD
1: Display three traverse ranges with MOD
Bit 1 –
0: Each traverse range has its own datum (and 3 memories
for the positions of the swivel head)
1: One datum for all traverse ranges
Bit 2 – Calibration data: Touch probe for workpiece
measurement:
0: One set of calibration data for all traverse ranges
1: Every traverse range has its own set of calibration data
Bit 3 – Calibration data: Touch probe for tool measurement:
0: One set of calibration data for all traverse ranges
1: Every traverse range has its own set of calibration data
PLC
RUN
628,
1541,
1552
MP7492.x Number of axis in which the same datum is to be set during
Datum Setting (with active preset table)
Input: 0 to 17
–1: Do not set a datum
PLC
RUN
1208
MP7492.0
MP7492.17
Datum set in the first axis
to
Datum set in the 18th axis
MP Function and input Software
version and
behavior
Page
To Next Page
Loading...
