HEIDENHAIN iTNC 530 HSCI - Page 573

July 2013 4.4 List of machine parameters 573
MP7650.x Handwheel counting direction (for HRA 110: for each axis)
MP7650.0 for X23 of the last machine operating panel in the
HSCI chain, and MP7650.4 for X29 of the MC main
computer
Input: Bit 0
0: Negative counting direction
1: Positive counting direction
Axis-specifically only for HRA 110:
Bits 0 to 17 represent axes 1 to 18
0: Negative counting direction
1: Positive counting direction
PLC
RUN
1507
MP7660 Sensitivity for electronic handwheel
Input: 0 to 65 535 [increments]
PLC
RUN
1507
MP7670 Subdivision factor for handwheel
Input: 0 to 10
PLC
RUN
1507,
1512
MP7670.0 Subdivision factor for slow speed
MP7670.1 Subdivision factor for medium speed (only HR 410)
MP7670.2 Subdivision factor for fast speed (only HR 410)
MP7671 Handwheel feed rate in the Handwheel operating mode
with HR 410
Input: 0 to 1000 [% of MP1020]
PLC
RUN
1512
MP7671.0 Slow speed
MP7671.1 Medium speed (only HR 410)
MP7671.2 Fast speed (only HR 410)
MP7672 HR 410, distance per handwheel step
Input: 0.0000 to 1.0000 [mm]
1512
MP7672.0 Slow speed
MP7672.1 Medium speed
MP7672.2 Fast speed
MP7674.x Handwheel, axis-specific subdivision factor
Input: 1 to 10
0: No limitation
PLC
RUN
1507
MP7675.x Handwheel, axis-specific maximum path
Input: 0.0001 to 10.0000 [mm]
0: No limitation
PLC
RUN
1507
MP Function and input Software
version and
behavior
Page