HEIDENHAIN iTNC 530 HSCI - Page 574

574 HEIDENHAIN Technical Manual iTNC 530 HSCI
MP7680 Machine parameter with multiple function
Format: %xxxxxxxxxxxxxxx
Input: Bit 0 – Memory function for axis-direction keys
with M4562
0: Not saved
1: Saved if M4562 is set
Bit 1 – Returning to the contour
0: Not active
1: Active
Bit 2 – Block scan
0: Not active
1: Active
Bit 3 – Interruption of block scan for STOP or M06
0: Interruption
1: No interruption
Bit 4 – Inclusion of programmed dwell time during the block
scan
0: Include the dwell time
1: Do not include the dwell time
Bit 5 – Start of calculation for block scan
0: Start from block with cursor
1: Start from beginning of program
Bit 6 – Tool length in blocks with normal vectors
0: Without R2 from tool table (south pole)
1: With R2 from tool table (center of sphere)
Bit 7 – Inserting a defined rounding arc or spline
0: Defined rounding arcs are always inserted
1: Defined rounding arcs are always inserted if the
acceleration from MP1060.x or MP1070 was
exceeded
PLC
RUN
892,
893,
1217,
1243,
1246,
1404,
1595,
1160
MP Function and input Software
version and
behavior
Page