HEIDENHAIN iTNC 530 HSCI - Page 586

586 HEIDENHAIN Technical Manual iTNC 530 HSCI
9136 Switch the touch probe on/off 1538
9137 Diagnostic information of the PL 510 Not with HSCI
9138 Read analog input of the PL 510 Not with HSCI
9139 Reset short-circuit monitoring of the
outputs on the PLD 16-8
Not with HSCI
9140 Set axis-specific feed-rate limit –
9141 Read axis-specific feed-rate limit –
9143 Activate the brake test 928
9144 Activate the emergency stop test 940
9145 Actual-to-nominal value transfer 847
9146 Save and reestablish actual position
values
989
9147 Assign a reference value to an axis 798
9148 Use nominal value as actual value 1533
9149 Set field angle/Read via PLC 1118
9150 Axis-specific reading of axis traverse
limits
625
9151 Select traverse range and axis
designation
626
9152 Select traverse range, axis display and
axis designation
627
9153 Switch the touch probe axis 1540
9155 Axis switchover from closed loop to open
loop
989
9156 Axis switchover from open loop to closed
loop
990
9157 Drive controller status 864
9158 Maximum torque 876
9159 Advance status message: Drives will be
switched off
864
9160 Status request for temperature
monitoring and I
2
t monitoring
913
9161 Enable the drive controller 865
9162 Status request of the drive controller 865
9163 Switching the operating modes 980
9164 Read the actual speed value of the motor 849
9165 Sample the current motor temperature 905
9166 Momentary utilization of the drive motor 919
9167 Supply voltage monitoring 903
9168 Interrogate the commissioning status 1026
9169 Axes for which I32 does not switch off
the drives
Not with HSCI
9170 Find the current torque 920
Module Function SW version Page