July 2013 5.1 Overview of modules 587
9171 Oriented spindle stop 971
9173 Speed-dependent wye/delta switchover 983
9174 Spindle status regarding wye/delta
switchover
984
9175 Switch the spindle 986
9179 Status information about spindle(s) 986
9180 Simulation of NC keys 1393
9181 Disable individual NC keys 1393
9182 Re-enable individual NC keys 1394
9183 Disable groups of NC keys 1394
9184 Re-enable groups of NC keys 1395
9185 Disable touchpad/Interrogate status 1395
9186 Call a soft-key function 1395
9187 Status of a soft-key function call 1396
9188 Call a soft-key function 1396
9189 Shut down the control 1262
9190 Start the operating times 1171
9191 Stop the operating times 1171
9192 Read the operating times 1172
9193 Set the operating times 1172
9194 Alarm when operating time exceeded 1173
9195 System time 1174
9196 Find the PLC cycle time 1666
9197 Start cyclic timers 1750
9200 Display/delete PLC soft-key row 1390
9201 Display/delete PLC soft key 1391
9202 Select/deselect PLC soft keys and PLC
windows
1391
9203 Activate PLC soft-key menu 1380
9204 Update the PLC soft keys 1381
9205 Set the word for acknowledgment of PLC
soft keys
1382
9206 Change the settings of the PLC soft keys 1383
9207 Replace PLC soft keys 1384
9208 Status information of the PLC soft keys 1385
9210 Open or clear screen mask for the PLC
window
1369
9211 Status of the large PLC window 1371
9215 Activate a PLC pop-up window 1193
9216 Pop-up window with tool selection list 1583
Module Function SW version Page
To Next Page
Loading...
