July 2013 5.2 Overview of markers and words 599
Marker Description Set Reset SW
version
Page
W 256 Gear code NC/
PLC
NC/
PLC
960
W 258 S code NC NC 965
W 260 Code for M function NC NC 1254
W 262 Tool pocket number NC NC 1611,
1629
W 264 Tool number NC NC 1611,
1629
W 266 Index number of a programmed indexed tool NC NC 1596
W 268 Tool magazine number NC NC 1590
W 270 Line number in help file NC NC 1190
W 272 Operating mode NC NC 1165
W 274 Code of the depressed key NC NC 1392
D 276 Code of the code number last entered via
MOD
NC NC 1265
D 280 First numerical value from FN19 NC NC 1713
D 284 Second numerical value from FN19 NC NC 1713
W 302 Number of the horizontal PLC soft key that
was pressed
NC NC 1389
W 304 Number of the vertical PLC soft key that was
pressed
NC NC 1380
W 320 Nominal speed value [min
–1
]NCNC 952
W 322 Actual speed value [min
–1
]NCNC952
W 336 Setting of the AFC soft key NC NC/
PLC
1235
W 342 Value from column PLC in table AFC.TAB NC NC/
PLC
1225
W 348 Current AFC status (0=inactive, 1=learn,
2=control)
NC NC/
PLC
1223
W 350 Error from AFC that led to NC stop NC NC/
PLC
1224
D 356 Programmed speed [0.001 min
–1
] NC NC 952,
960
D 360 Programmed feed rate NC NC 842
D 364 Nominal speed value [min
–1
]NCNC 952
D 368 Actual speed value [min
–1
]NCNC952
D 372 Maximum spindle speed including spindle
speed override [min
–1
]
NC NC 952
D 388 Current contouring feed rate [mm/min] NC NC 842
W 480-484 Analog input at X48 [0.1 V] NC NC 1529
W 486 - 490 Temperature input at X48 [0.5 °C] NC NC 1529
W 492 Percentage for spindle override (NC to PLC) NC NC 963
W 494 Percentage for feed-rate override (NC to
PLC)
NC NC 1156
To Next Page
Loading...
