HEIDENHAIN iTNC 530 HSCI - Module 9283 Generate Tool-Usage File

April 2013 1.9 PLC functions 63
Module 9283 Generate tool-usage file
This module is used to generate a tool-usage file for a specified part program,
including its subprograms.
Constraints:
 In order to create the file, the Test Run mode must be the active editing
mode on the control.
 The NC program is selected automatically and started in Test Run.
 Generation of the tool-usage file must be permitted with bit 2 of MP7246.
 The module must be programmed in a spawn job, since program run can
take a long time and submit subprograms would be blocked for a long time.
Call:
PS B/W/D/K <Mode>
0: NC program including subprograms
PS B/W/D/K <Additional parameter>
Content is currently not evaluated, but must be
programmed
PS B/W/D/K/S<Path>
0: Path of the NC program
CM 9283
PL B/W/D <Error code>
0: No error
1: Call was not in a submit/spawn job
2: Invalid value in the <Mode> or <Additional parameter>
parameter or
3: Invalid value in the <Path> parameter
4: Internal error
5: File in <Path> parameter does not exist, or invalid file
type
6: File generation not permitted or test run already started
7: Generation of .DEP not enabled (MP7246, bit 2)
8: Error during program run
Error code:
Marker Value Meaning
M4203 0 No error
1 Faulty execution of module
W1022 1 Mode parameter is invalid
2 NC program does not exist or wrong file type
6 Generation of .T.DEP files not enabled in the
configuration
8 Control is in an operating mode from which the call is
not possible, or test run is already started
11 An invalid PLC string was programmed
20 Call was not in a submit/spawn job
45, 58,
61
Internal error