674 HEIDENHAIN Technical Manual iTNC 530 HSCI
Example:
Entry of the link "Dependence on axis 5, compensation column C4": The B axis
wobbles relative to X during movement (error EAB)
The *.COM files have been extended by the columns C1 to C6. These
columns are addressed by a corresponding link in the transformation chain.
MP732 must be activated for rotary axes, because the kinematics
compensation (C1 to C6) is only applied to the traverse range of the axis.
In this example, there is a link to "A5C4". This links to axis 5 or to column 5 of
the CMA file, and to column C4 in the COM file saved there:
NR KEY AXIS COORD COMPTAB
...
Trans X 0.016
Trans Z 250.051
Trans A 0 A5C4
MachAxis B
MachAxis Y
MachAxis X
MachBase
MachAxis Z
Trans X -298.923
Trans Y 200.172
MachAxis C
...
[END]
To Next Page
Loading...
