HEIDENHAIN iTNC 530 HSCI - Page 710

710 HEIDENHAIN Technical Manual iTNC 530 HSCI
Step 2a
Determining the Z offset:
 Deactivate 3-D ROT
 Position A = –90
 Set the dial gauge to 0
 Set display Z = 0
Step 2b
Determining the Z offset:
 Position A = 0
 Move the Z axis until the dial
gauge reads 0 at the spindle
tip
 <Line no. [0] Column
COORD> = "determined value" –
cylinder radius
0
0